middle support block
ASSEMBLY INSTRUCTIONS
STEP 2
Set Item 3 down on the floor upside down. Rest Item 2 on top of the middle support block
(attached to Item 3 assembly). Hammer 1 x Item 5 through one of the two parallel holes in one of
the Item 4’s. Hammer the fixing through the corresponding hole in the middle support block (see
diagram) and finally through the corresponding fixing hole of the second Item 4. Place Item 6 and
thread Item 7 onto the exposed fixing thread. Tighten the nut by hand. Repeat this STEP for the
second fixing.
STEP 3
Hammer Item 8 through the single fixing hole in Item 4 and through the corresponding fixing hole
in Item 2. You will need to lift the end of the Support Beam to align the holes in the two parts
before pushing the fixing through. Place Item 6 and thread Item 7 onto the fixing thread. Tighten
the nut by hand. Repeat this STEP for the second fixing. Tighten all 4 x fixings with the socket
driver.
STEP 1
Fit Item 1 through the holes in Item 2 as shown. Hammer the fixing firmly into place so that
the square neck of the fixing bites into the Enviropol
®
. You will need to do this for each fixing
during the assembly.
1
2
4
8
2
2
3
5
3
STEP 1
7
6
2
3 of 8
