Firstly, remove the existing bollard from the base box by
removing the screws using an allen key (see Figure 1). When
removed unlock the box using the key supplied (Fig. 2), lift
open the unit and lift off the lens (Fig. 3) and put to one side.
Lift out the existing light plate using the handles,
shown above, to gain access to the inside of the unit
(Note: Do not unplug the plate until step 6).
1
2
4
3
Isolate the Safety Cutout Box by lifting the lever
and lifting out the removable section.
5
It is now safe to unplug the existing light plate
and then plug in the new LED light plate.
6
Now the new LED light plate is connected, the safety cut out box can
be replaced and the unit can be closed by repositioning the new LED
light plate (to check if the LEDs are working simply place your thumb
over the phototransistor), replacing the lens, closing the lid and locking.
7
11
10
9
8
2
1
3
2
4
Ensure all existing fixings are removed from the
hole (e.g. white nylon spacers). Insert a Nylon
Plug (provided) into each of the four holes on