Glamox B29004003, Руководство пользователя

Страница: 12 / 15

12
Factory settings
After resetting, the presence detector is preset via the <Fac-
tory settings> parameter with the following parameter values:
LMS MG PIR CLS SENSOR-R LONG
Parameter Value
Function C1/C2 Control
Terminal S1 assignment C1
Terminal S2 assignment C2
Brightness setpoint value C1 200 lux
Brightness setpoint value C2 200 lux
Room correction factor C1 0.3
Room correction factor C2 0.3
Detection sensitivity (PIR) Increment 3
Lighting time delay 5 min
Short-term presence ON
Energy saving mode eco
Presence switch-on delay 0 s
Presence time delay 10 min
Switch on dimming value C1 50%
Switch on dimming value C2 50%
Configuration type C1/C2 auto
Control speed Standard
Minimum dimming value 10%
Maximum dimming value 100%
Switch off brightness 10 min
Staircase light function OFF
Dimming speed: man. dimming Standard
Response after man. dimming School
Standby time 0 s
Standby dimming value 10%
IR group address C1 I
IR group address C2 II
Scene 1 C1 30%
Scene 2 C1 70%
Scene 1 C2 30%
Scene 2 C2 70%
Configuration button/RC Enabled
LED motion display OFF
L
The parameters can only be reset to the factory setting
with the app in combination with the app remote control.
General settings of
Broadcast <LMS MG PIR CLS SENSOR-R LONG BC>
Addressable <LMS MG PIR CLS SENSOR-R LONG>
Detection sensitivity
The detector has 5 sensitivity increments. The basic setting is
the middle increment (3). Increments 1 to 5 can be selected
and sent to the detector with the app in combination with the
app remote control.
Value range
Increment Sensitivity
1 Very insensitive
2 Insensitive
3 Standard
4 Sensitive
5 Very sensitive
L
By selecting the presence test mode, the set sensitivity
increment is not changed.
Lighting time delay
Value range
Lighting time delay C1, C2 10 s – 60 min
Short-term presence
If someone enters an unoccupied room only briefly and leaves
within 30 s, the lighting is switched off early after 2 min
(short-term presence). Short-term presence can be used for
the fully automatic device and semi-automatic device confi -
guration type.
Value range (Glamox Sensor-app)
The time delay is applied according to the set time delay. OFF
Short-term presence is active. ON
Energy saving mode: eco/eco plus
The "eco" selection stands for an ideal switching response,
while "eco plus" stands for maximum energy savings.
Value range (Glamox Sensor-app)
eco The time delay adapts to the user behaviour. The time delay
does not fall below the set value.
eco plus The set time delay remains unchanged (no self-learning
effect). Faster response to brightness detection than with the
eco mode.