Gladiator 10.0K, Руководство по эксплуатации продукта

Страница: 9 / 12

9
15.Remote Input Connection
This terminal is for turning the amplifier on and off. This requires a switched positive (+12V)
to power
“ON” the amplifier, this can be found on the rear of the head unit in the form of a
electric antenna output, or a remote on output. If not available you can wire to the ACC
position on the key.
16.Speaker Output
It offers built-in fuse to connect amplifier from battery directly. And see channel installation
diagram in this manual for correct speaker connection.
※
NOTE: SPEAKER CONNECTION FOR DAISY CHAIN
①
The mono woofer is connected between the + terminals of the two amplifiers and use
at least 12mm speaker wiring.
②
Install a 12mm wire link between the
– terminals of the two amplifiers. If this is not do
ne, the system will not function properly, and damage to the amplifiers may result.
③
Minimum final loudspeaker impedance must be become 1Ohm. The impedance und
er 1 Ohm may be given the loudspeaker unexpected damage.
TROUBLE SHOOTING
Problem Cause Solution
Power LED
not
“ON”
Fuse at battery
blown or not
installed Replace with correct fuse. Typically
twice the rating of the fuse that is on
the amplifier.
Improper
connection Check that the ground wire, power wire
and the remote wires are connected to
the correct terminals.
Protection
LED
“ON”
Fuse on amplifier
blown Replace with the correct AMP rated
fuse.
Amplifier too hot Move the amplifier into a ventilated
area; Check the amperage of battery.
Speaker wires
shorted Check that are no speaker wires
shorted to any other wire and also
check if any wire is shorted to the
vehicle chassis.
Internal malfunction Disconnect all wires except ground,
power and remote. Then turn the
amplifier
“ON”, if the protection LED is
still
“ON” ,then return for service