Glacier bay VDR3322A0, Инструкция по использованию и уходу

Страница: 7 / 12

8
Installing the soap dispenser
□
From under the sink, screw the soap bottle (I) onto the
soap assembly (G) shank. Insert the soap pump (F) down
into the soap assembly (G).
□
Insert the soap assembly (G) through the selected hole
in the sink. Secure the soap assembly to the sink with
the soap dispenser mounting nut (H) provided.
9
Making the water supply connections
□
Thread the nut (1) on the supply line onto the outlet of the
water supply valve (2) and tighten with a wrench. Do not
overtighten.
NOTE: The hot side inlet tube is indicated by a label. Avoid
twisting wires together or placing the wires close to each
other and damaging.
1
2
F
G
H
I
Flushing and checking for leaks
□
Pull the hose assembly out of the spout and remove
the spray head by unscrewing it from the hose in a
counterclockwise direction. Be sure to hold the end of
the hose down into the N sink and turn the faucet to
the warm position where it mixes hot and cold water.
□
Flush the water lines for one minute. This flushes away
any debris that could cause damage to internal parts.
Check for leaks.
□ Re-tighten any connections if necessary, but do not
overtighten. Reinstall the spray head by hand tightening
it back onto the spray hose in a clockwise direction.
IMPORTANT: After installation is completed, turn on the
hot and cold water supplies. Check for leaks. Do not lose
the gasket (1) in the hose.
11
Removing the quick connector
□ If it is necessary to remove the quick connector (1),
squeeze the tabs (2) on the quick connector and then
pull down to disconnect.
1
Pull
down
Squeeze
1
1
2