10
2
Removing the quick connector
□
If it is necessary to remove the quick connector
(1), squeeze the tabs (2) on the quick connector
and then pull down to disconnect.
Care and Cleaning
□
To clean, wipe down with a damp cloth and dry with a towel.
□
Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will
be voided.
Operation (continued)
Troubleshooting
Problem
Possible Cause
Solution
There are leaks from the
handle.
The bonnet nut has come loose and/or the
washer is dirty or damaged.
□
Tighten the bonnet nut.
□
Clean or replace the washer.
The water will not shut off
completely.
The cartridge is dirty or broken.
□
Remove the handle to check
the cartridge.
□
Clean or replace.
NOTE:
Refer to the service parts section in this manual for
a detailed drawing showing the location of the parts listed
below.
There is leaking from the
sink drain at the base of
the sink.
The sink has a rough or irregular surface.
□
Apply additional silicone sealant
to the beveled side of the drain
flange.
□
Retighten and test for leaks.
There is a low flow of
water.
The screen filter in the copper tubes is dirty.
□
Turn off the water supply at
angle stop and unscrew the
copper tubes from water supply
lines.
□
Remove the screen filter from
copper tubes and check for
debris.
Squeeze
Pull
down
2
1
1
