HOMEDEPOT.COM/GLACIERBAY
Please contact 1-855-HD-GLACIER for further assistance.
6
1
Flushing and checking for leaks
IMPORTANT:
After installation is complete, remove the
aerator from the faucet (A) to flush the water lines. Do not
lose the gasket (1) in the aerator.
□
Turn on the water supply and check for leaks.
If you discover any leaks, check your
connections to ensure they are installed
properly.
□
Remove the aerator and housing (if applicable).
Turn on the hot and cold handles to allow the
water to run for at least one minute. This
flushes away any debris that could cause
damage to internal parts.
□
Turn off the water and reinstall the aerator and
housing (if applicable).
Operation
Care and Cleaning
□
To clean, wipe down with a damp cloth and dry with a towel.
□
Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will
be voided.
Troubleshooting
NOTE:
Refer to the service parts section in this manual for
a detailed drawing showing the location of the parts listed
below.
A
1
Problem
Possible Cause
Solution
There are leaks from the
handle.
The bonnet nut has come loose.
□
Tighten the bonnet nut.
The aerator has an
irregular or reduced
water flow.
□
Remove the aerator and
check for debris.
□
Ensure that the rubber washer
is properly installed.
The water will not shut off
completely.
The rubber seat and spring is dirty or
broken.
□
Remove the cartridge to check
the rubber seat and spring.
□
Clean or replace.
The aerator is dirty or mis-fitted.
