4
3
Installing the shower arm
AA
3.1
3.2
B
CC
3.3
Insert a gasket (AA) between the end of the adjustable
shower arm (B) and the wall shower arm (3.1).
Turn the mounting nut (3.2) on the adjustable shower arm
(B) clockwise to tighten, but do not overtighten.
Once installed, tighten the set screw (3.3) on the mounting
nut (3.3) using the Allen wrench (CC).
4
Installing the showerhead
AA
A
B
Insert a gasket (AA) between the showerhead (A) and the
adjustable shower arm (B). Hand tighten the showerhead
(A), but do not overtighten.
Turn on the water and check for leaks. If leaks occur,
retighten connections or reinstall using more thread
seal tape (BB).
Care and Cleaning
Clean periodically with a soft cloth.
Avoid abrasive cleaners, steel wool, and harsh chemicals as these will dull the finish and void your warranty.
Installation (continued)
Troubleshooting
PROBLEM
POSSIBLE CAUSE
SOLUTION
There is low water pressure or a
missing spray pattern.
The showerhead spray nozzles are clogged.
Soak the showerhead in a solution of water and vinegar. Use a solution of 50% white vinegar
and 50% water overnight. The vinegar will break down any mineral deposits or sediment from
hard water and should improve the flow through your showerhead.
Debris has clogged the shower arm or showerhead.
Remove the showerhead and rinse debris from internal parts.
Turn on the hot and cold water and let it run for at least 30 seconds to flush debris from the lines.
Reinstall the showerhead.
The shower arm/showerhead
connection is leaking.
Showerhead connection is loose.
Gently and firmly tighten the showerhead, but do not overtighten.
There is leaking at the
connection between the
adjustable shower arm
and wall shower arm.
Shower arm connection is loose or thread seal tape is
not creating a good seal.
Retighten the adjustable shower arm to the wall shower arm.
If the leak continues, remove the adjustable shower arm from the wall shower arm to confirm
thread seal tape was applied properly. Remove and reapply thread seal tape, if needed.
