1
2
Installing the connector
□
Installing the 1/2" pipe nipple
Installation
3-Option 1
5
3-Option 2
□
Turn the seat (E1) counterclockwise to remove it
from the slide bar (E).
Put the tape (L) and seat (E1) on the wall by order
as shown below.
□
Apply thread sealant tape to both
threaded ends of the 1/2” pipe nipple, H or I;
whichever is needed for the application.
Suction Installation
Screw connector (B) in a clockwise motion onto
the outlet pipe nipple.
HOMEDEPOT.COM
Please contact 1-855-HD-GLACIER for further assistance.
Tape Installation
NOTE:
This product includes two pipe nipples, but only one
will be used during installation. When installed, the nipple
should extend no more than 1/2" (12mm) past the finished
wall, and no less than 1/4" (7mm) past the finished wall. One
of the two included nipples should work for your application,
but if neither size works for your application, you can find a
variety of pipe nipple sizes at your local Home Depot store.
B
□
3/8±1/8
"
H or I
NOTE:
Make sure the wall is clean and there are no rough
surfaces and gaps on the wall.
L
E1
E1
23.34
"
25.74
"
□
Turn the seat (E1) counterclockwise to remove it
from the slide bar (E).
Push the suction assembly (J) and clamping
plate (K), by order as shown below, tight to the wall.
□
NOTE:
Clean the wall before installation and make sure the
wall’s surface is smooth (like glass wall or glaze tile).
K
J
E1
23.34
"
25.74
"