8
Installation
9
Shower stall installation
WARNING:
Injury may occur if you do not install the top
of the assembly onto the ceiling first.
NOTE:
For tub ledge installation see step 7.
NOTE:
If needed, the height may be reduced by
carefully cutting the short tapered tube. Refer to the
Troubleshooting section at the end of this manual.
□
Lift the entire assembly into position over the shower stall.
□
Compress the top of the unit against the ceiling at the
desired location.
□
Move the bottom end into place on the shower floor so that
the unit is in a vertical position.
□
Place the tape strips (EE) around the seams of the tubes.
8
Preparing the bottom shelf assembly
for shower stall installation
NOTE:
For tub ledge preparation see step 6.
□
Slip the tapered end of the short tapered tube (D) into
the untapered end of the bottom tube of the assembly.
□
Place the soft vinyl end cap (DD) on the short tapered
tube (D).
DD
D
bottom shelf assembly
EE
the entire assembly
Installation (continued)
