12
DISPENSING COFFEE
6.
2.
3.
Touch “PRE-HEAT”button. If “READY” light is not ON.
Do not open lid when red light is ON
“Ready ” light will go on only when hot water temperature is
201
0
F. Water temperature goes down to 195
0
F if Brewer was
not used for 3 hours. “Ready” light might keep on blinking if
water level is low. Please check the bottle.
4.
a. Open lid and place a COFFEE CAP-
SULE when “ ” LED is blinking.
b. Press coffee capsule down by your hand
to pierce bottom of the capsule.
c. If Brewer was switched off, wait up to 10 minutes until the “Ready” light is
ON. If “READY” light is blinking, it indicates there is not enough water in
storage tank. Wait until water is pumped up. Check if bottle has water.
LED is green.
7.
5.
By default 8 oz, middle cup is pre selected
for you. If you wish to have different size cup,
touch your choice.
LED is green.
Unlock button will be blinking. Touch UNLOCK and touch “START” button within 2 seconds. LED is red.
Place a coffee cup on top
of brewers drip tray.
8.
10. To fill next cup repeat procedures from 3 to 7, after “ready” light is ON.
Wait few seconds
for coffee to start
pouring.
9.
Wait until red light changes into
green then open lid
START
READY
PRE-
HEAT/
START
READY
PRE-
HEAT/
START
READY
PRE-
HEAT/
START
READY
PRE-
HEAT/
START
READY
PRE-
HEAT/
START
READY
PRE-
HEAT/
START
READY
PRE-
HEAT/
11.
PRE-Heat
If coffee brewer was not in use for 3 hours temperature would go back to stand by 90
0
C
/194
0
F
to make coffee requite
to touch PRE-heat button again.
Operating Instructions:
1. Make sure you have turned on RED hot water switch at the back. See No. 16 on page 10.
START
READY
PRE-
HEAT/
