PROGRAMMING - USING PROGRAMMING BUTTON
General connection
1.
Connect the network cable and verify that the unit powers up and that the network connection is working.
Factory reset
1.
Disconnect the network cable.
2.
Press and hold the reset button, while reconnecting the network cable.
3.
The unit will change IP address to the default IP and login.
4.
The unit will restart in the bootloader.
USER INTERFACE
Settings are made through the web based user interface. All that is needed is a modern web browser to access and
change settings .
The instructions for the user interface described below are valid for firmware 1.32.
FACTORY DEFAULT SETTINGS
When using the system for the first time, or if a factory reset has been made, the following settings are used:
Product IP number
192.168.0.10
Subnet mask
255.255.255.0
Default router
192.168.0.1
Login
1.
Open a web browser.
2.
In the address field, type in the selected unit’s IP-address. Default is 192.168.0.10.
3.
The user interface login page is shown.
4.
The user is prompted to create a username and password based on the password policy.
