09
10
2.4.3.2 Installation with base
（
Accessories need to be purchased separately
）
Step 1:
As shown in Figure 7, place the battery on the base and tighten limit brackets located at
the four corners (screw: M4*10 outer hexagonal and internal torx combination screw; torque:
1.6 N.m; 10pcs in total )
Step 2:
As shown in Figure 7, stack the second battery neatly on the first one and tighten the
limit brackets with a T20 screwdriver(screw: M4*10 external hexagonal box Combination screw ;
torque requirement: 1.6 N.m; 10pcs ).
Step3:
Refer to Step 2 and stack the battery in turn, as shown in Figure 9
。
Step 3:
As shown in Figure 5, connect the communication cable, and dial code after the
connection. Switch "2" for the bottom battery, and "4" for all other batteries.
Note
The communication wiring between the battery and the inverter has a special sequence.The
requirements of communication wiring connection are shown in Figure 6.
Note
A bracket (including a left bracket and a right bracket) is used for each 2 batteries
RJ45 connector
on the battery side
RJ45 connector
on the inverter side
Figure 6 Communication wiring
&Kodak name
Figure 7 Install the first battery
Figure 8 Install the second battery
Figure 9 Stack and install 6 batteries
(Take G2500-48 as an example)
Left bracket
Right bracket
The
adapted
i
nverters
are provided by
Kodak OG range.
