Giros SYM0X4, Инструкция по эксплуатации

Страница: 24 / 36

-3-
Horizontal
position
TIPS: When matching signal, keep the
quad copter on horizontal position
to fast matching and start a stable
flight.
FUNCTIONS MODE SWITCH, FINE-TUNING
RESET AND LEVEL CALIBRATION
Step 3: Push the throttle lever to the highest position
and then pull it back to the lowest position,this time
there will be one clear sound sending out from the
transmitter,this shows that the quad copter has
entered into the pre-fly state.
CAUTIONS:
1.When the indicator of the transmitter appears eternal bright,however, the
indicator of the helicopter appears slow flashing, this means that decoding is
not successful. This time please disconnect the power both of the quad
copter and transmitter, then repeat the pre-flying steps.
2.If the helicopter is tilting to one side abruptly or spinning while hovering,
please switch off the power both of the quad copter and transmitter and then
repeat the pre-flying steps.
3.When the indicator of the quad copter keeps flashing slowly, it means that the
quad copter has entered into the low voltage protection state.This time you
need to charge the helicopter.
Mode switch function:
Keep pressing the button A,then switch on the power
of the transmitter, you can select Mode 1 or Mode 2.
Resetting function :
Keep pressing the button B, then switch on the power of the
transmitter.Enter into the Trimming & Resetting Mode
(It is highly suggested that the freshman should reset the
trimmer first before starting the first flight.)
Level calibration function
If quad-copter always fly to a side when starting, please re-match signal and place it on
a horizontal plane. Than turn the two levers to the lower right corner (as left image) for
seconds, when indicator keep light up, it finishes auto level calibration.
A
B