EN
USER’S MANUAL
STX
12
5.3 TARE AND ZEROING
To tare, place the weight to be tared on the hook. Once the weight is stable, press the
button or the
B
button on the remote and the
weight will be saved in the hook’s memory. Press
to remove the tare
.
If there is nothing hanging on the hook, the weight should be zero. If it shows any other value while empty, use the
hook button or
the
B
button on the remote to set it to zero.
5.4 SUMMING FUNCTION
When the display reading is stable and the weight exceeds 20 divisions, press the
C
button on the remote to sum up the measures. By pressing
the
C
button after each weighing, the display will show the number of measures (“n32”), and after 2 seconds the hook will return to the normal
weighing mode.
To display the previous weight, as well as the previous total weight, press the
A
button at any time. To cancel the summing function, press the
B
button on the remote to return to the normal weighing mode
5.5 HOLD FUNCTION
Press the
D
button on the remote to fix the reading on the display for 30 seconds.
Press the
D
button on the remote again to turn off the Hold function and enter normal weighing mode.
5.6 ENERGY SAVING
If the hook remains at zero and inactive for one minute, the display will go blank, depending on the battery saving setting (there will only be
one dot at the bottom of the display). As soon as weight is loaded onto the hook or a button is pressed, the display will return to showing the
current load value.
5.7 REMOTE CHANNEL SELECTION
1. With the hook off, press the keys
y
at the same time. The display will show: “Dsp X”. (function not available)
2. Press the key
to go to the next option.
3. Now the display will show “
CHX
” (“
X
” representing the current channel "
0-7"
)
4. Press
key to select a channel and then press
to go to the next option
5. The display will show “
Ft0
”. (Command configuration). Keep in
"0 "
6. Keep at
"0 "
. Press
to return the weighing mode and restart the device.
Note: The channel is already configured with the corresponding control for each hook. Only configure couando the control is
controlled
6. CALIBRATION
1. Switch on the hook and, during initialisation, press and hold down the
D
button on the remote to display “
CAL SP
”.
2. If you press the
A
button on the remote control, the display will show “
CAL 00
” when it has no load on the hook; press the A button and
the display will briefly show “------” and finally “
LOAD
”.
3. Press the
D
button on the remote control to enter the value of the calibration weight. Press the
C
button once, or hold down the
D
button
to increase the value selected and press
D
once to change between digits.
4. Hang the calibration weight and wait a few seconds until the stability indicator lights up.
5. Press the
A
button on the remote control, the display will briefly show “------” and finally show the weight value. Remove the weight,
switch off the hook and switch it back on to test it.
Содержание 261246
