4: Rear housing panel and installation frame
i
To prevent the ingress of moisture, we recommend inserting the cables from below (10).
o
When the cables enter below, use an installation frame (9). Insert the rear housing panel
(7) into the installation frame.
o
Do not use an installation frame for surface cable entry from the side or from above, but
instead penetrate one of the the thinner areas of the rear housing panel.
i
Do not remove the water-permeable closure of the condensation water hole (8).
o
Run the connection cable into the connection compartment through a rubber sleeve (4).
o
Fasten the rear housing panel on the installation location with two screws (6) in such a way
that the condensation water hole is at the bottom.
Configuring the motion detector
On the rear side of the housing cover of the motion detector, there is one adjuster each for the
follow-up time (11) and the brightness threshold (12) ( 5).
5: Setting the follow-up time and the brightness threshold
The range of the motion detector can be set in three stages by sliding the internal housing (13)
( 6).
82523522
19.05.2011
4/8
Observer 70
