o
Press the
Prog
button for at least 20 seconds.
The status LED flashes after 4 seconds. After 20 seconds the status LED flashes faster.
o
Release
Prog
button and press briefly once again within 10 seconds.
The status LED flashes more slowly for approx. 5 seconds.
The actuator is reset to default setting.
Setting the minimum brightness
The minimum brightness can be set within a range of approx. 1...67 %, if, e.g. the light flickers
at low brightness or to compensate for differences in brightness.
o
Turn operating mode switch (1) to the
min.
position.
o
Adjust brightness with the radio transmitter.
o
Turn operating mode switch to the original position again.
When leaving the position
min.
, the minimum brightness is saved.
Save switch-on brightness
o
Switch on light.
o
Adjust brightness with the radio transmitter.
o
Press button
Prog
(2) for longer than 4 seconds.
The light switches off briefly and then switches on again to the new switch-on brightness.
Switch-on brightness is saved.
i
Alternatively, the switch-on brightness can be saved with a radio transmitter, e.g. wall
transmitter.
6 Appendix
The icon confirms the conformity of the product to the relevant guidelines.
6.1 Technical data
Rated voltage
AC 230 V ~
Mains frequency
50 / 60 Hz
Standby power
max. 0.5 W
Ambient temperature
-25 ... +70 °C
Contact type
µ
Control voltage
0.5 ... 11 V
Control current
max. 50 mA
Switching current
Ohmic
6 A
Fluorescent lamps
3 AX
Minimum switching current
100 mA
Connected load
Ohmic load
1380 W
Capacitive load
690 VA (560 µF)
Connection
single stranded
0.75 ... 4 mm²
Finely stranded with conductor sleeve
0.75 ... 2.5 mm²
Dimensions Ø×H
53×28 mm
Total length power cable
max. 100 m
Total length of control cable
max. 100 m
Radio frequency
868.3 MHz
Transmitting power
max. 20 mW
Transmitting range in free field
typical 100 m
32581002
10499448
13.03.2014
5/11
eNet
Radio control unit 1-10V, 1-gang Mini
