Gira 834 Plus, Установка, Запуск, Эксплуатация

Страница: 16 / 28

Installation and start-up
16
06.2017/V 1.2
2.6.3 Testing the connection quality of the installation
As outlined in chapter 2.1, radio connection quality depends on various factors.
i
Note:
Test the connection quality before installation.
It is advisable to test connection quality prior to installing the devices so that another
installation location can be selected if necessary.
i
Note:
The description applies both to pre-configured devices that are part of a radio
emergency set and to devices added to a set!
To assign devices to a radio emergency set, see 2.6.1.
Important:
Only test the connection quality of several devices one after another.
For each device, implement steps 1 and 2 in succession.
Step Set the device into test mode Visual and acoustic display of the
connection quality in the call module
1 1. Device:
If the buzzer is activated, an acoustic signal is
output.
Press the programming button
for less than 3 seconds. The devices exchange information.
This process takes several seconds.
2 Display in the call module: repeated 3 times within 5 seconds
a) Connection very good
b) Connection good
c) Critical connection
3 Testing a further device
Begin again with step 1.
4 Result: Critical connection
Find another installation location
for the device and observe the
points specified in chapter 2.1.
Then test again.
Flashes 1 x
Flashes 2 x
Flashes 3 x
Flashes 3 x