GIRA
Info
4-channel blind/shutter actuator 230 V~
Installation Instructions
4-channel blind/shutter actuator 230 V~
1/07
Page 1 of 10
System information
This device is a product of the Instabus KNX/EIB-sys-
tem and complies with KNX directives. Technical
knowledge obtained in Instabus KNX training courses
is a prerequisite to proper understanding.
The functionality of this device depends on the soft-
ware. Detailed information on loadable software and
attainable functionality as well as the software itself
can be obtained from the manufacturer’s product da-
tabase.
Planning, installation and commissioning of the unit is
effected by means of KNX-certified software. The full
functionality with KNX commissioning software from
version ETS3.0d. onwards.
The product database, technical descriptions and
conversion programs and other utilities are available
in the Internet at www.gira.de.
Function
Designated use
• Switching of electrically operated blinds, shutters,
awnings and similar devices for mains voltage
230 V AC or extra-low voltage 12...48 V DC
• Installation on DIN rail in small distribution boards
Product features
• Manual output control, provisional operation
• Suitable for AC motors 230 V and DC motors
12...48 V
• Automatic run time detection with 230 V AC drives
• Direct control of blind/shutter position
• Direct control of slat position
• Scene function
• Checkback of run status, blind/shutter position and
slat position for bus and manual operation
• Forced top and bottom position from primary con-
trol
• Safety function: 3 independent wind alarms, rain
alarm, frost alarm
• Sun protection function
• Integration into the temperature management of
the building possible
• Disabling of individual outputs by hand or via the
bus possible
4-channel blind/shutter actuator 230 V~
Order no.: 1039 00
Safety instructions
Electrical equipment must be installed and fitted
by qualified electricians only.
Failure to observe the instructions may cause
damage to the device and result in fire or other
hazards.
The device is not suited for safe disconnection of
the mains supply.
For parallel connection of several drives to an
output it is indispensable to observe the corres-
ponding instructions of the manufacturers.
There is otherwise risk of irreparable damage to
the drives.
Use only blinds/shutters with mechanical or
electronic limit switches. Check the limit switch-
es for correct adjustment.
Do not connect mains voltage consumers to-
gether with SELV/PELV consumers to the same
shutter actuator.
These operating instructions are part of the pro-
duct and must be left with the final customer.
i
State of delivery: output control via keypad
enabled, provisional operation.
