GIRA
Info
Multifunction Radio Transmitter
Installation Instructions
Multifunction Radio Transmitter
05/01
Page: 2 of 8
C
PK
E4
GY
E3
GN
E2
YE
E1
WH
1
2
3
4
5
6
7
8
9
YE
GN
GY
PK
Plug the connector of the eight-wire multi-colour cable and
the white antenna into the multifunction transmitter (Fig. C:
Rear view).
Wire colour assignment:
Yellow (YE) and yellow/black: input E1.
Green (GN) and green/black:
input E2.
Grey (GY) and grey/black:
input E3.
Pink (PK) and pink/black:
input E4.
The black-striped wires form a common reference potential.
Antenna
To obtain maximum radio transmitting power unroll and
install the antenna in a straight line.
Keep away from large-surface metal parts (e. g. metal door
frame). Do not strip, shorten or extend the white antenna.
D
1x
CR2032
Battery
The multifunction transmitter is powered by a lithium button
cell (CR 2032). The device comes with the battery inserted.
Safety and disposal instructions
Attention:
Keep button cells away from children. Seek medical
advice immediately when button cells have been
swallowed.
Remove used batteries immediately and discard without
polluting the environment.
Replace battery by identical or equivalent types only.
E
Battery Change
1. Use a screwdriver and open the battery compartment (Fig.
D) carefully.
2. Remove the exhausted battery.
3. Put a fresh battery on the
⊕
contact of the battery holder
first, as shown in Fig. E. Then press slightly to snap the
battery in place. Ensure correct polarity (
⊕
= up). Keep the
battery grease-free.
4. Close the battery compartment.
