Routing the sensor cable in-wall
Figure 4: In-wall routing of the sensor cable
i
For in-wall routing of the sensor cable, use only shielded cables. Recommendation: J-Y
(ST)Y 2x2x0.6 mm.
o
Insert the cable through the hole (6) in the insert and route it through the cable duct (7) to
the terminal block (8) (Figure 4).
i
The terminal block is included with the covers with sensor evaluation.
o
Connect the cable (see "Connecting sensors to terminal block")
Routing the sensor cable with surface-mounting
Figure 5: Surface-mounted routing of the sensor cable
o
For surface-mounted routing of the indoor sensor (9), cut off the plug.
o
Route the sensor cable behind the supporting plate (10) and through the cable duct to the
connecting terminal (8) (Figure 5).
o
Connect the cable (see "Connecting sensors to terminal block")
32537112
10860473
11.09.2013
4/6
Blind control system
Blind controller insert without auxiliary input
