.23.
6. Operation
.22.
Selecting the “User-Def” menu will access to the following submenu (see Figure 6.12),
Figure 6.12
Press the UP/DOWN keys to scroll through items. Press the ENTER key to edit the
highlighted item. Press the UP/DOWN keys again to change the setting. Press the ENTER
key to save the setting. Press the ESC key to cancel changes and returns to the previous
menu.
OV-V: 262V
UN-V: 210V
OV-V: 240---270V
UN-V: 180---210V
OV-G-F: 60.3
—
62.0Hz(50.3---52.0Hz)
UN-G-F: 57.0
—
59.5Hz(47.0---49.5Hz)
Below is the setting range for “User-Def”. Using this function, the limits can be changed
manually.
6.5.2 Grid ON/OFF
This function is used to start up or stop the power generation of Solis Single Phase
Inverter (see Figure 6.13).
Grid ON
Grid OFF
Figure 6.13 Set Grid ON/OFF
Screens can be scrolled manually by pressing the UP/DOWN keys. Press the ENTER key
to save the setting. Press the ESC key to return to the previous menu.
6.5.3 Clearing Energy
NOTE:
Please, set "Grid ON" to start up the inverter after the settings (refer to
Section 6.5.2). Otherwise the inverter won't start up.
NOTE:
The " User-Def" function can be only used by the service engineer and
must be allowed by the local energy supplier.
6.6 Arc fault(for AFCI version)
Solis Single Phase Inverter can integrate with AFCI module which can detect the arc in DC
circuit. If arc fault happen, it can only be removed manually.
During start up inverter will check AFCI module. If the check is OK, inverter will start
normally. If the check is fail, LCD will show below:
Figure 6.16 AFCI check fail
AFCI Check Fail
Restart<ESC>
Press <ESC> for 3 seconds
, the inverter will restart. If the fault happen again, please turn
off inverter to restart. If the fault still happen, please contact us.
This function is used to set the new password for menu “Advanced info.” and “Advanced
information” (see Figure 6.14).
Maintenance or replacement could clear or cause a different value of total energy. Use this
function could allow user to revise the value of total energy to the same value as before. If
the monitoring website is used the data will be synchronous with this setting automatically.
(see Figure 6.15).
Press the DOWN key to move the cursor, Press the UP key to revise the value. Press the
ENTER key to execute the setting. Press the ESC key to return to the previous menu.
Enter the right password before set new password. Press the DOWN key to move the
cursor, Press the UP key to revise the value. Press the ENTER key to execute the setting.
Press the ESC key to return to the previous menu.
6.5.3 New Password
6.5.4 Calibrate Energy
Figure 6.14 Set new password
Figure 6.15 Calibrate energy
YES=<ENT> NO=<ESC>
Password: 0000
YES=<ENT> NO=<ESC>
Energy:0000000kWh
6. Operation
