.45.
.44.
7.5.13 Debug Parameter
Figure 7.24
Debug
Parameter as shown as below:
This section is applicable to maintenance personnel only.
Press the UP/DOWN keys to scroll through items. Press the ENTER key to select
.
Press the DOWN key to scroll and press the UP key to change the value.
Press the ENTER key to save the setting. Press the ESC key to cancel
.
changes and return to the previous menu.
→
S16DAT1: +0000
S16DAT2: +0000
7. Normal operation
7. Normal operation
7.5.12 Restart HMI
The
function
is
used
for
restart
the
HMI
.
This function is applicable by maintenance personnel only, wrong operation
will prevent the inverter from reaching maximum power.
7.5.8
.
1 Enable logic interface settings
Please follow below settings to enable the
DRM
. DRM default setting is “OFF” , if DRM set “ON”,
but the logic interface un-connected to the switch or the switch is open, the inverter HMI will
display “Limit by DRM” and the inverter output power will be limited to zero.
1. Select
Initial Settings
2. Select
DRM
and set it
“
ON
”
7.5.10 HMI Update
HMI
Current
Ver
.: 02
YES
=<
ENT
>
NO
=<
ESC
>
Selecting “Updater” displays the sub-menu shown below:
This section is applicable to maintenance personnel only.
Updater is for updating LCD firmware.
Press the ENTER key to start the process.
Press the ESC key to return to the previous menu.
Figure 7.22
7.5.9 Restore Settings
There are 5 items in initial setting submenu.
The
screen
shows
as
below
:
Restore setting could set all item in 7.5.7 special setting to default.
Figure 7.21 Restore Settings
Are
you
sure
?
YES=<ENT> NO=<ESC>
Press
the
Enter
key
to
save
the
setting
after
setting
grid
off
.
Press
the
ESC
key
to
return
the
previous
mean
.
7.5.11 External EPM Set
Figure 7.23 Set the
Fail
Safe ON/OFF
YES=<ENT> NO=<ESC>
Fail
Safe Set:ON
This function is turned on when the EPM is external
.
7.5.14 FAN Test
This section is applicable to maintenance personnel only.
