4
Installation
Fasten wall bracket on the wall with enclosed
screws, making sure that the sliding sides of wall
bracket face away from the wall and the smooth
surface of the wall bracket is flush with the wall
(as shown). Depending on the sliding surface,
alternative screws may be needed. Note that
the bracket should be placed so that the wildest
portion of the plate is horizontal. When screws
are tightened, there will be no gap between the
screw head and surface of the plate.
Mount the unit by sliding/dragging the two
cutting line on the backside of unit over sliding
arms of wall bracket on the wall.
Plug into 100 or 230V, 50 or 60Hz AC and unit
is ready for use. It is recommended to install the
product before use.
Operation
Power cord should be plugged in a properly
grounded socket. After plugging the power cord
into outlet, turn the power switch to ON position.
The attached instrument head will automatically
light up when handles are lifted from the handle
cradle. Adjust rheostat on handle until desired
light is obtained. Turning rheostat clockwise will
decrease the light, counterclockwise increase
