Gilson VALVEMATE, Руководство пользователя

Страница: 23 / 72

2-10
Installation
2
Checking the V
A
L
VEMA
TE’
s Configuration
Checking the VALVEMATE’s
Configuration
Refer to the following instructions if the
VALVEMATE is being controlled via its RS-232
or GSIOC port.
Checking the Unit ID
The unit ID identifies the VALVEMATE when it is
being externally controlled. For communication to
occur, the VALVEMATE and the computer must
“agree” on the same unit ID number. Refer to
Appendix C, GSIOC Control for more information
about the GSIOC.
At the factory, Gilson set the VALVEMATE’s unit
ID to 35. There is no need to change this number
unless it conflicts with another unit’s ID number.
For example, if you had two VALVEMATEs
connected along the GSIOC, assign one of them a
different ID number.
To modify the unit ID assigned to the
VALVEMATE:
1 Turn on the VALVEMATE.
2 Press the MODE key until you see the following
message on the display:
Unit ID: 35
3 Use the up or down arrow key to select a
different unit ID.
4 Press the MODE key to save the change.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com