GILMAN Gemini GMFH15W, Руководство пользователя

Страница: 5 / 15

5
1. Carefully remove the appliance from the plastic bag and the carton.
2. Place the appliance on a flat surface floor.
3. Pull out the water tank, pick up the tank cover, add water to the water tank to max.
line-around 420ml. (Suggest to use pure water)
OPERATING INSTRUCTION
4. When adding water, the water level shall not exceed the highest (max) indicating
scale-around 420ml, nor lower than the lowest (min) indicating scale-around 75ml;
5. After adding water, don’t tilt, lie on the side or invert the water tank to prevent water
from infiltrating the circuit board.
6. Don’t dip the tank lid into the water because it has a circuit board inside.
7. Close the water cover and water tank, gently push the water tank in to the appliance,
and push in position properly.
8. Inset the product power cord plug into the power socket, press the main On/Off but-
ton to “I” (ON) position, hear the sound of “di”, indicating that the appliance has been
connected to the power, the power indicator is red, into the standby state, according
to the need to select the function.
9. Power button : press this button in standby state, the power indicator turns green,
the appliance starts to work, default fan & mist mode, press this button again, the
appliance shutdown into standby state; press this button under heating mode, the
appliance will turn off about after 30 seconds delay.
10. Heating mode button : Press this button when the appliance is on, the Low-heat
indicator lights up, the appliance is in low heat mode, press the heating button again, the
High-heat indicator lights up, the appliance is in high-heat mode, press the heating
button in third, the product turns to fan mode. Fan => Low-heat mode => High-heat
mode, cycle work.
11. Mist button : press this button when the appliance is on, the mist indicator will light
up and the mist function will start. Press this button again, the mist indicator is off and
the mist function is closed.
Note:
It is recommended to clean the water tank every 72 hours during use. This appli-
ance has a 72-hour cleaning reminder function: (both on and standby time), after
72 hours accumulated, the appliance enters the cleaning reminder state: the mist
indicator and the power indicator flash at the same time, and the buzzer sounds
once every 10 seconds. Press the power button of the control panel, the appliance
exits the cleaning reminder state and cleans the water tank. Clean the water tank