THIS WARNING IS GIVEN IN COMPLIANCE
WITH CALIFORNIA'S PROPOSITION 65:
WARNING
This product contains chemicals known to the
State of California to cause cancer, birth defects
or other reproductive harm.
9/12/2013
RAISED RUNWAY SYSTEM
800-637-3090
Page 5 of 5
INSTRR100
www.gillathletics.com
All rights reserved.
Copyright
2013 by Gill Athletics.
INSTRUCTION MANUAL
Vinyl base Panel keeps the
walls from bowing out
Corner Patches close the wall
frame after the foam is inserted
Rigid foam logs are inserted into
the wall frame to give it shape
Vinyl Wall Frame holds the
foam inserts in place
will fit in the space allotted. See page 3 for details.
shoveling the sand out later. It is also recommended that only plastic shovels be used.
recommended to lay thin plywood down inside the sand pit before filling it with sand. This will help protect the vinyl when
the four inside corners attach the corner patches. Place the vinyl base panel in the frame and velcro it down to the walls. It is
1. Start by deciding where to locate the runway. Measure out and mark it off to ensure that the runway and soft shell sand pit form
SETTING UP A LONG JUMP TRIPLE JUMP RAISED RUNWAY
connect the sections. See page 4 for details. Make sure to put locate the Triple Jump Runway Sections correctly, see page 3.
2. Insert the foam logs into the vinyl frame wall as shown below. Close the flaps of the vinyl casing to secure the foam in place. At
3. Start laying out the runway sections, starting with the Long Jump Runway Section. Install the leveling feet as you go. Use the
leveling feet to adjust the deck height to remove any small differences where the runway sections meet. Use the Velcro straps to
4. Install take off boards and/or blanking lids where needed.
