GILES FSH-3.5, Руководство по эксплуатации и обслуживанию

Страница: 15 / 68

5
Model: FSH-3.5
&
FSH-4 Installation
2. Installation
This section summarizes the procedures necessary to install your new FSH-3.5 or FSH-4 Hood. Before
installing or servicing this equipment, please read the contents of this manual thoroughly. Following these
procedures will help ensure a safe and proper installation.
Your Ventless Hood should arrive palletized with a wooden protective frame, wrapped in machine applied
stretch-wrap, and secured to by means of high-tensile plastic strapping. Perform the following steps to
unpack the unit:.
1. Position the palletized unit in an area that has sufficient space for unpacking.
2. Cut and remove stretch-wrap and all strapping.
3. Use a hammer and pry-bar to remove the wooden crate from around the unit
2-01. Unpacking
!! IMPORTANT NOTE:
•
If the palletized unit shows any signs of damage, immediately inspect the equipment and other packed
components, and notify the freight company of any and all damages.
•
Use suitable equipment to lift the hood and carefully move it away from the pallet ... see Section 1-4.4
for hood weights. Take precautions not to damage to the hood’s bottom skirting. If possible, it is
advisable to rig and lift the hood from the topside, utilizing the hood’s hanging brackets.
•
Exercise care when removing the wooden framing from around the unit.
•
Failure to comply with these
CAUTION
notices may result in minor or moderate injury, equipment or
property damage, and void the warranty.
!
CAUTION
NOTE:
• A HVAC specialist may be required for some installations to confirm proper
air exchange and the heat load capabilities of the on-site AC system.
•
Exhaust ventilation is recommended for areas in which recirculating hoods are used. We recommend
50 CFM per lineal ft. of hood.
•
This amount could vary based on local codes and the site specific installation requirements.