Giken GSK Series, Инструкция по эксплуатации

Страница: 76 / 109

75
８．
Supplementary explanation
８－１
Operation auxiliary function
①
Zero times check function
：
Zero times checked every block tightening.
Carried out in the presence or absence check by the program setting screen check Box for checking the
presence or absence.
②
History data storage function
After tightening comprehensive judgment outputs, make the history data stored in each driver at the reset input
as a trigger.
When the data is confirmed the data was read from GSK_PC- automatic measurement screen. -
(The history data is read to PC by the all or Specified axis when the read switch on setting software.There is the
cancel SW.)
③
Waveform sampling function
It can save 2048 the 2 kinds of waveform data in the each driver. 2 kinds of waveform data are waveform data1
and waveform data2.
When the number of data is over 2048, next tightening data will be overwritten.
Waveform data1: save in 10msec Interval from the block start to block end.
Waveform data2: save in 0.5degree Interval from the real tightening snag torque to real tightening finished
It is possible at the setting software that it saves the waveform data 1 after tightening and it can get waveform
data 2 by the always-on connection (online).
８－２
Driver function
Regeneration capability: If the drive voltage exceeds a certain value, it has a built-in regenerative circuit to be
consumed by the internal resistance. (Regenerative resistor is external.
）
Discharge function: The driver spontaneously discharges by the LED.
Analog monitor: Monitor signal output from the panel surface check pin (can be selected by parameter)
Standard load inertia : JL(Standard load inertia)
≦
30JM(30 times of the moter inertia)
Tightening history storage: The data about 6,000 has been saved in the E2PROM of each axis.
The call of history, you can use the setting software.
Alarm history function: GSK has 16 times the storage of the alarm.
The call of alarm history, you can use the setting software.