Gigaset C590, Руководство пользователя

Страница: 60 / 73

59
Service (Customer Care)
Gigaset C590 / SEA / A31008-M2101-Y701-1-7619 / appendix.fm / 14.04.2010
V
e
rsion 4, 16.0
9
.2005
Questions and answers
If you have any questions about the use of
your phone, you can contact us 24/7 at
www.gigaset.com/customercare.
The table below contains a list of common
problems and possible solutions.
The display is blank.
1. The handset is not switched on.
¥
Press and hold the end call key
a
.
2. The battery is flat.
¥
Charge the battery or replace it
( ¢
page 11).
Not all menu options are displayed.
The menu display is reduced ( Standard mode ).
¥
Activate extended menu display ( Expert
mode
•
) (
¢
page 24).
No Base flashes on the display.
1. The handset is outside the range of the base.
¥
Move the handset closer to the base.
2 The range of the base is reduced because eco
mode is activated.
¥
Deactivate eco mode (
¢
page 44) or
reduce the distance between the handset
and the base.
3. The base is not switched on.
¥
Check the mains adapter of the base
( ¢
page 9).
Please register handset flashes on the display.
Handset has not been registered with the base or
has been deregistered.
¥
Register the handset (
¢
page 45).
Handset does not ring.
1. The ringtone is deactivated.
¥
Activate the ringtone (
¢
page 53).
2. The telephone only rings when the phone
number is transferred.
¥
Activate the ringtone for anonymous calls
( ¢
page 53).
You cannot hear a ringtone/dialling tone from
the fixed line network.
The phone cord supplied has not been used or
has been replaced by a new cord with the wrong
pin connections.
¥
Please always use the phone cord supplied or
ensure that the pin connections are correct
when purchasing from a retailer (
¢
page 9).
Error tone sounds after system PIN prompt.
You have entered the wrong system PIN.
¥
Reset the system PIN to 0000 (
¢
page 55).
Forgotten the system PIN.
¥
Reset the system PIN to 0000 (
¢
page 55).
The other party cannot hear you.
You have pressed the mute key
h
. The handset
is "muted".
¥
Activate the microphone again (
¢
page 27).
The number of the caller is not displayed
despite CLIP.
Calling Line Identification is not enabled.
¥
The caller should ask the network provider to
enable Calling Line Identification (CLI).
You hear an error tone when keying an input
(a descending tone sequence).
Action has failed/invalid input.
¥
Repeat the operation.
Watch the display and refer to the user guide
if necessary.
You cannot listen to messages on the network
mailbox.
Your PABX is set for dial pulsing.
¥
Set your PABX to tone dialling.
Exclusion of liability
Some displays may contain pixels (pic-
ture elements), which remain activated
or deactivated. As a pixel is made up of
three sub-pixels (red, green, blue), it is
possible that pixel colours may vary.
This is completely normal and does not
indicate an error.