4
Gigaset A18H / CHN / A31008-M2071-Y101-5-7619 / starting.fm / 19.10.2011
The idle screen is displayed. The
handset name and the internal
handset number are shown. The
handset is already registered to
the base.
If you want to register
further
handsets
, you have to register
each individual
handset manually (
Handsets are assigned the lowest available internal
number (1-4). If four handsets are registered you will
have to deregister one handset before you can regis-
ter another.
Initial charging and discharging of the
batteries
If the handset is activated, the flashing battery icon in
the top right of the display indicates that the batteries
are being charged. During handset operation, the
battery icon indicates the charge status of the batter-
ies.
The correct charging level can only be displayed if the
batteries are first fully charged
and
discharged.
¤
Place the handset in the charging cradle for at
least
twenty
hours.
¤
Then remove the handset from the charging cra-
dle and do not replace it until the batteries are
completely discharged.
Activating/deactivating the handset
¤
Press and
hold
the
a
key to activate or deacti-
vate the handset.
If you place a deactivated handset in the base station
or charging cradle, it will automatically activate.
Handset out of range
If the handset is out of range of the base station the
antenna icon
Ò
will flash on the display. If the signal
becomes poor during a call the earpiece will briefly
intermit voice transmission by emitting an out of
range warning tone. In this case you should reduce
the distance to the base station. If the signal becomes
too low the line is disconnected.
Setting the date and time
Set the date and time on the base station so that the
correct date and time can be assigned to incoming
calls and the alarm can be used. The date and time is
synchronised with all registered handsets.
Your phone is now ready for use
If you have any questions about using your phone,
please read the tips on troubleshooting ("Writing and
editing text"
page 13) or contact our Customer
Using the phone
Control key
Entering numbers and text
¤
Enter digits or letters using the keypad
~
.
You will find information on multiple line input in the
appendix to this user guide,
When entering the time and date etc.:
¤
Overwrite the highlighted (flashing) character.
Correcting incorrect entries
In editing mode the display shows
{
in the lower
left corner.
To correct incorrect characters when editing:
¤
Press the
{
key
A
to delete the character to
the left of the cursor.
¤
Insert new characters at the cursor position.
U
Steady:
Full, more than1 hour talking time
Flashing:
Charging
=
Steady:
Less than 1 hour talking time
Flashing:
Almost flat. Put the handset into the
charging cradle to recharge.
Please note
◆
After the first battery charge
and
discharge
cycle you may replace your handset in the
charging cradle after every call.
◆
Always repeat the charging and discharging
procedure if you have removed the batteries
from the handset and re-insert them.
◆
The batteries may warm up during charging.
This is not dangerous.
◆
In a while, the charge capacity of the batteries
will decrease for technical reasons.
Ò
=
Gigaset 1
In idle mode
t
Open the calls list.
s
Open the phone book.
In menu and lists
p
Scroll up/down line by line.
In input fields
t
Move to previous character.
s
Move to next character.
During a call
p
Adjust the earpiece volume.
