12
www.gigaipc.com
GIGAIPC reserves the right to modify or revise the content at anytime without prior notice.
How to combine the QBiX-JMB-CMLA47EH-A1 system & PCI-E extension chassis (Cont.)
9
10
11
8
4. Assemble 4 screws (Torsion : 4 - 5 kgf.cm) to fix A parts on the QBiX-JMB-CMLA47EH-A1 system
(refer Figure 7)
※
Recommend to use at least 15cm length screwdriver.
5. Insert the PCIe riser card into PCI-E slot of QBiX-JMB-CMLA47EH-A1 system from Top to Bottom.
(refer Figure 8)
6. Assemble 5 screws (Torsion : 4 - 5 kgf.cm) to fix B parts on the QBiX-JMB-CMLA47EH-A1 system.
(refer Figure 9)
7. Remove the screws on the IO Bracket, and then insert the graphic card into the PCI-E slot
of PCI-E extension chassis from top to bottom. Connect the power cord in the extension card to
the power connector of the graphics card (refer Figure 10 and 11)
B
NOTE 1 : To connect 1 or 2 power cables on the graphic
cards is depends on different graphic card spec.
NOTE 2 : If only 1 power connector on the graphic card, you
can choose any one of two power cables for
connection.
NOTE 3 : The graphic card model uses on above picture
(refer Figure 11) is for reference only.
7
A
