3
MD800
Safety Information
Important Notice
Due to the transmission and reception properties of cellular communications, data can occasionally
be lost or delayed. This can be due to the variation in radio signal strength that results from
changes in the characteristics of the radio transmission path.
Although data loss is rare, the environment where you operate the GSmart MD800 may adversely
affect communications. Variations in radio signal strength are referred to as fading. Fading is
caused by several different factors including signal reflection, the ionosphere, and interference
from other radio channels.
Potential Hazards
Do not operate the GSmart MD800 in an environment that may be susceptible to radio interference
resulting in danger; specifically:
Areas where prohibited by the law.
- Follow any special rules and regulations and obey all signs and notices. Always turn off the
host device and remove the GSmart MD800 from the card slot when instructed to do so, or
when you suspect that it may cause interference or danger.
Where explosive atmospheres may be present
- Do not operate your GSmart MD800 in any area where a potentially explosive atmosphere
may exist. Sparks in such areas could cause an explosion or fire resulting in bodily injury or
even death. Be aware and comply with all signs and instructions.
- Users are advised not to operate the GSmart MD800 while at a refueling point or service
station. Users are reminded to observe restrictions on the use of radio equipment in fuel
depots (fuel storage and distribution areas), chemical plants or where blasting operations are
in progress.
- Areas with a potentially explosive atmosphere are often but not always clearly marked.
Potential locations can include gas stations, below deck on boats, chemical transfer or storage
facilities, vehicles using liquefied petroleum gas (such as propane or butane), areas where the
air contains chemicals or particles, such as grain, dust or metal powders, and any other area
where you would normally be advised to turn off your vehicle engine.
Near Medical and life support equipment
- Do not operate your GSmart MD800 in any area where medical equipment, life support
equipment, or near any equipment that may be susceptible to any form of radio interference.
In such areas, the host communications device must be turned off. The GSmart MD800 may
transmit signals that could interfere with this equipment.
On an aircraft, either on the ground or airborne
-
In addition to FAA requirements, many airline regulations state that you must suspend
wireless operations before boarding an airplane. Please ensure that the host device is
turned off and your GSmart MD800 is removed from the card slot prior to boarding aircraft in
order to comply with these regulations. The GSmart MD800 can transmit signals that could
interfere with various onboard systems and controls.
