Before installing drivers, check with your vendors to see if they have already installed all the drivers
with the operating system, if not, please follow the steps below:
1. You can find the Utility Driver CD like the one shown below:
2. Put the CD into the CD R-W or DVD-RW (optional) Drive. An Auto Run installation screen will
appear.
1.16 Touch Screen Calibration
If your M1028 M1028 CafeBook Computer already has an operating system installed, it is best to
install all necessary device drivers in order for he hardware to properly function.
The stylus pen together with the system touch-screen LCD display provides you a touch-screen
operation by emulating the industry standard mouse left click. Below are the two conditions that you
need to calibrate your touch-screen.
• The first time Windows is installed and boot up. The active cursor is shifted; not exactly the same
position where the stylus pen tip is tapped.
• Periodically when you find the active cursor is shifted away from the screen position where the
stylus pen tip is tapped.
To calibrate the touch-screen, go into
Desktop Manu
=>
PenMount Control
=>
Device
=>
PenMount 6000 USB Resistive Digitizer
=>
Configure
=>
Calibrate
=>
Standard Calibration
. In
the
Setting
screen, select
Calibrate
. Then follow instruction to complete calibration.
Note: You need to set screen display resolution to right resolution 1280x768 or 1024x600
(depends on your hardware specification) before proceeding with the calibration.
1.17 Use your M1028 as a Tablet PC
The screen of M1028 is convertible to simulate a Tablet PC. Follow the steps to use this function.
1. Open the lid (the screen display) of M1028.
2. On the top center above the keyboard is the pivot connecting the display panel to the bottom case.
There is a sign
3. Follow the sign to turn the screen clockwise up to 180 degree so that the screen is facing out.
4. Lay the turned screen down into the flat position. The keyboard will be covered by the display. Use
the stylus or simply touch the screen to operate M1028 as a Tablet PC.
5. When done with Tablet PC, reverse the above instruction (erect the screen to 90 degree, turn
counterclockwise to 180 degree) to set M1028 back to original position.
* Attention: Please note that the screen can only rotate at 180 degree clockwise. Be sure to turn the
screen according to the sign. Forcing the screen to turn at the wrong angle will cause serious
damage to M1028.
1.18 Operating Temperature
Operating Temperature : 10ºC to 35ºC
Chapter 2 Battery
