Gigabyte 3D Galaxy II GH-WIU02, Руководство пользователя

Страница: 19 / 24

5-2 Radiator Installation
5-2-1 Lock the radiator rack to the
radiator with screws.
5-2-2 Remove the 2 screws on the
power supply at the rear of
chassis as shown.
Note: For the first time of pouring liquid coolant into the tank; the radiator should be
lay down flat to facilitate exhaust air to ensure the liquid cooling system to function
silently. Installing the radiator in accordance with the following step 5-2 ; make
sure all the air bubble in the tube has been removed to ensure the performance of
cooling.
5-1-2 Turn on the power until all liquid coolant
drains into the tubes; the red light on the
bottom of the PCB will blink and bleep; the
system will turn off automatically within 4
seconds. (This is normal or initial refilling of
liquid coolant since the tube and radiator are
not full of liquid.)
5-1-3 Open the lid of the tank again to refill the tank
with liquid coolant and than close the lid. Turn
on the power one more time and repeat this
step until the water is no longer lower than
the low water-level.
Be aware of abnormal leakage. If the installation was correct and the tube
clips are fastened, and the liquid cooling system leaks, please turn off the
power immediately and drain out all coolant. Contact GIGABYTE
™
dealers
or GIGABYTE
™
service center.
19
En
glis
h