019-03 - Electric fryer
7
Warning!
- Beware of inexpert handling!
- Old and dirty oil or frying fat can represent a real fire
hazard; make sure only new oil or frying fat are used
each time you start frying.
- The food you intend to fry should always be dry; wet
food causes the oil to foam and overflow.
- Frying excessively large quantities of food at a time
also causes the oil to foam; never exceed 1.5 kg.
- If the level of oil in the bath falls below the low level
mark stamped on it, the risk of fire will increase.
- Never leave the appliance on without any oil in it. The
lid delivered with the appliance should always be kept
within easy reach. In case of fire, it should be used to
douse the flames.
Ignition
Check that the oil drain release is closed. Fill the bath with
oil up to the level marked. Turn on the main switch
upstream of the appliance. Turn the knob from ‘0’ to any
temperature between 100°C and 195°C; the pilot lights will
come on. The green light means that the appliance is on,
while the orange one indicates that the resistances are on.
As soon as the required temperature is reached, the oran-
ge light will go off. To turn the appliance off, simply turn the
knob back to '0'.
Emptying the bath
Open the oil drain tap. The appliance is fitted with an oil-
collecting container complete with filter.
CLEANING AND TAKING CARE OF THE
MACHINE
Warning!
Never clean the appliance with jets of water, whether di-
rect or pressurised. Allow the machine to cool down
before cleaning
Before starting to clean the appliance, disconnect from the
mains. Using the hook provided (see drawing 2), you can lift
out the elements to make cleaning the appliance easier and
far more thorough. Lift the elements as far as they will go. To
lower them after cleaning, pull out the button on the left hand
side. All steel parts should be washed in warm water, using a
neutral detergent, then rinsed thoroughly to eliminate any re-
sidual detergent. Dry using a dry cloth. Avoid using abrasive
or corrosive detergents which could damage the steel.
What to do if not using the appliance for
a long time
Thoroughly clean and dry the machine as described.
Disconnect the power supply.
What to do if something goes wrong
If anything goes wrong, immediately turn the appliance off,
then turn off the power supply at the switch located upstream
of the appliance, and call the aftersales department.
MAINTENANCE
All maintenance should be carried out by qualified personnel
only. Before carrying out any maintenance work, unplug the
appliance or turn off the switch upstream of the appliance.
USING THE APPLIANCE
- Bottone
di sgancio
- Pull out button
- Bouton de
déclanchement
- Auslösungknopf
2