019-03 - Electric fryer
6
Before beginning installation, remove all packaging from
the appliance. Some parts are protected with an adhesive
film which should be carefully removed.
Any remnants of glue should be thoroughly cleaned using
suitable substances such as benzine. Under no circum-
stances should abrasive substances be used.
Fit the legs to the appliance; the appliance must be level-
led using a spirit level. Slight irregularities can be levelled
by adjusting the feet themselves.
The main switch or plug should be located in the vicinity of
the appliance and easy of access. We recommend instal-
ling the machine under a range hood so that all the fumes
are removed as quickly as possible. If the appliance is to
be installed near walls, dividing walls, kitchen equipment
or decorative pannelling, these should be in non-inflam-
mable material or covered with non-inflammable material.
Make sure that all fire prevention standards and safety pre-
cautions are strictly adhered to.
Warning !
MODELS KFE1 KFE15 KFE20
if this model is going to be mounted on its own, it must
be fixed to the floor.
Fixing accessories are included.
The appliance should be fitted following the indica-
tions given in the drawing below.
Legal and technical requisites
When installing the appliance, the following safety stan-
dards must be adhered to:
- Local accident prevention standards
- Current CEI standards.
Installation
Installation, start-up and maintenance should only be car-
ried out by expert personnel. All work required to install
the appliance should be carried out in compliance with all
local standards and regulations. The manufacturers decli-
ne all responsibility where poor performance is due to in-
correct installation in disregard of the above conditions.
Warning!
In compliance with international regulations, when
connecting the appliance to the mains power supply, a
device with a minimum aperture of 3 mm between con-
tacts must be fitted upstream of the appliance, al-
lowing omnipolar disconnection of the appliance from
the mains.
Wiring
When choosing the lead wire, make sure it has the fol-
lowing characteristics: it should be at least of the H07 RN-F
type and its section should be large enough for the ap-
pliance (see "Technical specifications and dimensions",
page 5).
Wire entry is underneath the appliance, on the left hand si-
de. The terminal board is at the front, behind the control
panel.
Pass the wire through the core hitch and wire clamp, plug
the leads into their terminals on the board and secure
them.
The earth lead must be a little longerthan the others so
that it is the last lead to disconnect if the wire clamp
breaks.
Unipotential
The appliance must be connected up to a unipotential sy-
stem. The connection screw is located underneath the ap-
pliance, on the right hand side. It is labelled.
Warning!
The manufacturers cannot be held responsible for any
damage due to inadequate or incorrect installation.
Under such circumstances the guarantee will be con-
sidered null and void.
Start-up
Before using the appliance for the first time, thoroughly
clean out the oil bath (see paragraph entitled “Cleaning
and Taking Care of the Appliance”).
Check that the appliance is connected up properly and
start according to instructions overleaf.
INSTALLATION INSTRUCTIONS
RETRO
ARRIERE
BACK
ATRÁS
RÜCKSEITE
ACHTERAAN
1