B. Rebuilding an Array
Rebuilding is the process of restoring data to a hard drive from other drives in the array. Rebuilding applies only
to fault-tolerant arrays such as RAID 1, RAID 5 or RAID 10 arrays. The procedures below assume a new drive
is added to replace a failed drive to rebuild a RAID 1 array. (Note: The new drive must have equal or greater
capacity than the old one.)
Turn off your computer and replace the failed hard drive with a new one. Restart your computer.While in the
operating system, launch the
Intel
®
Optane
™
Memory and Storage Management
utility from the Start menu.
1. Go to the
Manage
menu and click
Rebuild to another disk
in
Manage Volume
.
2.
Select a new drive to rebuild the RAID and click
Rebuild
.
3. The
Status
item on the right of the screen displays the rebuild progress. After the RAID 1 volume rebuilding,
the
Status
will display as
Normal
.
A-2. Installation Guidelines
1. Go to
Settings\IO Ports\SATA And RST Configuration
and make sure
RST Control PCIe Storage
Devices
is set to
Manual
. Then depending on which M.2 connector you install the Optane
™
memory in, set
the corresponding
PCIe Storage Dev on Port XX
item to
RST Controlled
.
2. After re-entering the operating system, launch the
Intel
®
Optane
™
Memory and Storage Management
application from the Start menu. If you install more than one Optane
™
memory, please select which one
you are going to use. Then select which drive to be accelerated. Click
Enable Intel
®
Optane
™
Memory
. All
data on the Optane
™
memory will be erased. Make sure you back up the data before continuing. Follow the
on-screen instructions to proceed. When completed, restart the system.
3. Launch the
Intel
®
Optane
™
Memory and Storage Management
application from the Start menu and make
sure the Intel
®
Optane
™
Memory has been enabled.
4.
If you want to accelerate the system drive, you can select specific folders, files, or applications to accelerate
using the
Intel
®
Optane
™
Memory Pinning
function. (The Optane
™
memory used must have at least
32 GB capacity.)
•
An Optane
™
memory cannot be used to accelerate an M.2 PCIe SSD.
•
If more than one Optane
™
memory is installed, you can select only one of them to accelerate
your SATA-based boot drive. The other(s) can only be used as data drive(s).
•
Do not abruptly remove the Optane
™
memory. Doing so will cause the operating system to stop
functioning correctly.
•
If you want to change/remove the Optane
™
memory, you must disable it using the
Intel
®
Optane
™
Memory and Storage Management
application first.
•
After enabling the Optane
™
memory, the related BIOS settings will remain even after a BIOS
update.
- 44 -
Содержание Z590M GAMING X
Страница 47: ... 47 ...
