16) CLR_CMOS (Clear CMOS Jumper)
Use this jumper to clear the BIOS configuration and reset the CMOS values to factory defaults. To clear
the CMOS values, use a metal object like a screwdriver to touch the two pins for a few seconds.
•
Always turn off your computer before clearing the CMOS values.
•
After system restart, go to BIOS Setup to load factory defaults (select Load Optimized Defaults) or
manually configure the BIOS settings (refer to Chapter 2, "BIOS Setup," for BIOS configurations).
Open: Normal
Short: Clear CMOS Values
17) BAT (Battery)
The battery provides power to keep the values (such as BIOS configurations, date, and time information)
in the CMOS when the computer is turned off. Replace the battery when the battery voltage drops to a low
level, or the CMOS values may not be accurate or may be lost.
You may clear the CMOS values by removing the battery:
1. Turn off your computer and unplug the power cord.
2. Gently remove the battery from the battery holder and wait for one minute. (Or use a metal
object like a screwdriver to touch the positive and negative terminals of the battery holder,
making them short for 5 seconds.)
3. Replace the battery.
4. Plug in the power cord and restart your computer.
•
Always turn off your computer and unplug the power cord before replacing the battery.
•
Replace the battery with an equivalent one. Damage to your devices may occur if the battery is
replaced with an incorrect model.
•
Contact the place of purchase or local dealer if you are not able to replace the battery by yourself
or uncertain about the battery model.
•
When installing the battery, note the orientation of the positive side (+) and the negative side (-)
of the battery (the positive side should face up).
•
Used batteries must be handled in accordance with local environmental regulations.
Pin No.
Definition
Pin No.
Definition
Pin No.
Definition
1
VBUS
8
CC1
15
RX2+
2
TX1+
9
SBU1
16
RX2-
3
TX1-
10
SBU2
17
GND
4
GND
11
VBUS
18
D-
5
RX1+
12
TX2+
19
D+
6
RX1-
13
TX2-
20
CC2
7
VBUS
14
GND
18) F_U32C (USB Type-C
™
Header with USB 3.2 Gen 1 Support)
The header conforms to USB 3.2 Gen 1 specification and can provide one USB port.
F_USB30
F_U
B_
F_
F_
_ B
BS_ B
SB_ B
_S
S_ _ B
_U _ B
S
12
3
12
3
1 2 3
12
3
1
1
1
1
BSS
S
_S
SSU
1
2
3
S3
BSSS
U
__
3
F_USB3F
S
_
S
_
S
_
SF
B_
B_
F
_0
S S
_0F
_F
_
_
__B
U
S
_S
_
SF_
B
USB0_B
B_
B_
F_USB3
F_USB303
_
_3U
S_
20
10
11
1
- 19 -
