Giant J3-90, Инструкция по эксплуатации

Страница: 12 / 21

www.valuehobby.com/j3-90.html
Section6. Elevator Installation
Step1. Remove the coverings for horizontal
stabilizer.
Step2. Slide the horizontal stabilizer into the slot in
the fuselage, and center the stabilizer in the
fuselage.
Step3. Trace the outline of the fuselage on the
horizontal stabilizer using a felt‐tipped pen.
Step4. Remove the covering from the horizontal
stabilizer inside the line drawn in the previous step
.
Step5. Position the stabilizer and elevator on a flat
surface as shown, and make sure they are in
alignment with each other. Then center the joiner
wire on the elevator and mark the elevator
Step6. Drill the holes in the elevator on the location
marked in the previous step.
Cut a groove from the hole to the end of the
elevator for joiner wire.