Giant GP7142, Руководство по эксплуатации

Страница: 3 / 8

PULLEY INFORMATION
Pulley selection and pump speed are based on
a 1725 RPM motor and “B” section belts. When
selecting desired GPM, allow for a ±5% tolerance
on pumps output due to variations in pulleys, belts
and motors among manufacturers.
1. Select GPM required, then select appropriate
motor and pump pulley from the same line.
2. The desired pressure is achieved by selecting
the correct nozzle size that corresponds with the
pump GPM.
U.S. (Metric)
Volume* ................................................. 38.4 GPM .................... (145.2 LPM)
Discharge Pressure* .............................. 2610 PSI ....................... (180 bar)
Power Consumption .............................. 69.0 BHP ...................... 51.5 kW
Speed ........................................................................................... 700 RPM
Inlet Pressure (maximum) ...................... -4.35 to 140 PSI ........... (-0.3 to 10 bar)
Plunger Diameter ................................... 1.7” ............................... 42mm
Plunger Stroke ....................................... 2.0” ............................... 52mm
Crankshaft Diameter .............................. 1.9” ............................... 48mm
Key Width .............................................. 0.6” ............................... 14mm
Crankshaft Mounting ..................................................................... Either side
Shaft Rotation ........................................ Top of pulley towards manifold
Temperature of Pumped Fluids* ............ Up to 140
o
F ................. (60
o
C)
Inlet Ports ...................................................................................... (2) 2-1/2” NPT
Discharge Ports ............................................................................ (2) 1-1/4” NPT
Weight .................................................... 375 lbs. ........................ (170 kg)
Crankcase Oil Capacity ......................... 1.6 Gal. ........................ (6.0 liter)
Fluid End Material ......................................................................... Cast Iron
NPSHR .................................................. 28 feet of head .............. 8.5 meters of head
*For continuous duty and/or with fluid temperature above 104°F (40°C), reduce pressure and
flow by 10%
Specifications
Model GP7142
Consult the factory for special requirements that must be met if the
pump is to operate beyond one or more of the limits specified above.
HORSEPOWER INFORMATION
Horsepower ratings shown are the power re-
quirements for the pump. Gas engine power
outputs must be approximately twice the
pump power requirements shown above.
We recommend that a 1.15 service factor be
specified when selecting an electric motor as
the power source. To compute specific pump
horsepower requirements, use the following
formula:
(GPM X PSI) / 1450 = HP
3
GP7142 HORSEPOWER REQUIREMENTS
RPM GPM 800 PSI 1000 PSI 1500 PSI 2000 PSI 2610 PSI
300 16.5 9.1 11.4 17.1 22.8 29.7
400 21.9 12.1 15.1 22.7 30.2 39.4
500 27.4 15.1 18.9 28.3 37.8 49.3
600 32.9 18.2 22.7 34.0 45.4 59.2
700 38.4 21.9 27.4 41.1 54.9 69.1