Bagger Unit Installation - 3 Bag Units
(Cont.)
Install the plate/channel assembly onto the
support assembly using two 5/16-18 x 3/4” car-
riage bolts through the top holes, and two
5/16-18 x 1-1/4” carriage bolts for the bottom
holes. Secure with four 5/16-18 serrated
flange nuts.
Set bottom of support assembly onto pins in
bottom of bumper mount.
Holding support assembly upright, align holes
in support assembly with corresponding holes
in bumper mount and reinforcement brace.
Slide 5/8 x 17” locking pin through holes in
bumper mount, securing with 2-1/2” oal bridge
pin. Slide 3/8 x 18” locking pin through holes
in top of reinforcement brace, securing with 1-
7/8” oal bridge pin.
Now tighten all brace hardware securely.
Install Cover Latch Arm onto support assembly
by first inserting two 5/16-18 x 3/4” hex bolts
out through corresponding holes in the support
assembly. Then fit the latch arm over bolts
and secure with two 5/16-18 serrated flange
nuts.
unit assembly
3
11
GVTP ZVBB-R0203.1
Bolts
