Giant-Vac TLG101651KH, Руководство оператора

Страница: 3 / 12

2
UNIT ASSEMBLY & MOUNTING
UNIT ASSEMBLY
Note: Please refer to parts list for correct part identification and placement
FRONT PUSHER PLATE ASSEMBLY:
•
Thread Pusher rod (Parts list ref. #18) out through lower threaded hole in rear channel of power
unit frame (#1), allowing approximately 3” to protrude from rear of unit.
•
Slide Pusher rod handle (#19) through hole in top of pusher rod, securing with 3/8” lock nut
(#19a).
•
Slip one ½” flat washer (#22) onto small tapped end of pusher rod, followed by front pusher plate
(#24), small hole facing unit, guiding end of pusher rod through hole. Secure pusher plate with
second ½” flat washer, 3/8” flat washer (#21), 3/8” lock washer (#23) and 3/8” x ¾” hex bolt (#20).
Repeat for other side. Refer to Picture (1).
REAR HOLDER ARM ASSEMBLY:
•
Insert one 5/8” x 4” hex bolt (#26), fitted with one 5/8” flat washer (#28) through bushing side of
hole in rear holder arm. Threaded side of bolt should protrude from flat side of arm.
•
Attach holder arm, flat side toward unit, to bracket in top rear of unit, securing with second 5/8” flat
washer and 5/8” lock nut (#27). Note: leave arm loose enough to swivel up for easier mounting.
Repeat for other side.
DISCHARGE ELBOW ASSEMBLY:
•
Position elbow retaining ring (#16a) over the exhaust elbow and stack (#16). Secure elbow to the
machine with (4) 5/16 x 1” bolts (#16b), (4) 5/16” pivot spacers (#16c), and (4) 5/16” lock nuts
(#16d) tighten securely grease upper and lower rings so elbow can swivel. Next secure stack
extension (#16e) over end of elbow with the stack extension retainer (#16g) using the 3/8” wing
bolt (#16f), 3/8” lock nut washer (#16h) and 3/8” wing nut (#16i), then adjust to fit leaf box. Refer
to Picture (2).
INTAKE HOSE ASSEMBLY:
•
Install intake flange (#5) to power unit with 5/16” x ¾” bolts (#6) and lock washers (#6a). Flip up
intake flange safety cover (#5a; this should already be installed onto the intake flange by the
factory) and install quick-attach hose adapter (#5b) to intake flange.
Important: Be sure to lock
hose adapter into intake flange by pushing adapter into flange as far as it will go, then
twisting into locking slots
. Secure adapter by installing 5/16” fender washer and 5/16” plastic
knob nut onto each adapter stud. Install 5/16” locknut onto each stud, tightening snugly against
knob nut to prevent loosening and/or loss of knob nut, and subsequent disconnection of hose
adapter. Refer to Picture (3).
•
Attach intake hose (#8) to hose adapter using one hose clamp (#7). Assemble hose support band
(#9) around intake hose approximately 3-1/2 feet from free end of hose using 5/16” hex head bolt
(#10) with two nuts (#10a) locked together. Now attach intake nozzle (#11) to loose end of intake
hose using the remaining hose clamp.