Giant-Vac 35hp Series, Руководство по сборке

Страница: 5 / 22

2
safety rules regarding outdoor power equipment (cont.)
• Belts and belt guard components are subject to
wear, damage, and deterioration, which could
expose moving parts or allow objects to be thrown.
Frequently check components and replace with
manufacturer’s recommended parts, when
necessary.
• Check operation of brake, tail and license lights
frequently. replace as required.
• Use only factory authorized replacement parts
when making repairs.
• Always comply with factory specifications on all
settings and adjustments.
• Only authorized service locations should be
utilized for major service and repair requirements.
• Never attempt to make major repairs on this unit
unless you have been properly trained. Improper
service procedures can result in hazardous
operation, equipment damage and voiding of
manufacturer’s warranty.
3
unit assembly & set-up
Note: Please refer to Parts List for correct part identification and placement. Parts list reference
numbers are called out by sheet number followed by reference number(s) on that sheet: (1:1) indicates
Sheet 1, reference number 1; (2:32,34-38) indicates Sheet 2, reference numbers 32 through 38 excluding
33; etc.
Important Safety Note: To prevent unit rollover during assembly and set up,
lock rear support leg in lowermost position possible. Failure to do this may
result in injury or death and/or damage to unit or property.
DISCHARGE ASSEMBLY
Safety Note: Assistance is required when installing discharge stack. If access to
lifting equipment is possible, it is highly recommended.
•
Place stack & elbow assembly (3:1) atop power
unit, with discharge directed toward towing
hitch. Insert twelve 1/2-13 x 1-3/4” hex bolts
(3:2), each fitted with one flat washer (3:3),
through bolt flange holes, securing with flat
washers, lock washers and nuts (3:3-5).
Tighten securely.