unit assembly
3
Using proper lifting equipment, attach each of the
four Caster Assemblies to blower with four 3/8-16
x 1” hex bolts, each fitted with one flat washer,
inserting bolts up through caster and mounting
pads, then securing with lock washers and nuts.
Tighten securely.
Slip Eyebolt, fitted with one 5/16” hex nut and flat
washer, through top hole in left rear corner brack-
et of blower, securing with second flat washer, lock
washer and second nut. Do not tighten yet.
Slide Door Control Rod down through hole in eye-
bolt. Thread 1/2-20 hex nut onto end of rod.
Thread end of rod into Ball Joint atop Bell Crank.
Tighten nut securely against ball joint, making sure
‘L’ shaped bend in top of rod faces toward right
side of machine (from operator’s perspective).
Now tighten eyebolt hardware and check for free
movement of rod.
Attach each of the two Strut Assemblies to blower
by inserting one 3/4-10 x 2-1/2” hex bolt into one of
the three corresponding holes in rear corner brack-
et. Slip spherical rod end onto bolt, making sure
that grease fitting on other end of strut faces up,
then secure strut with one 3/4” flat washer, lock
washer and nut. tighten securely.
