Copyright
Gianni Industries, Inc. All Rights Reserved.
P-MU-GS705N-30 Ver. E Publish:2011.12.16
©
2-1
GS705N-30 Shear Lock Installation Instruction
Specifications
Connecting Diagram
Caution:
Make sure that the "+" and "-"
wires are connected correctly.
Failure to observe polarity will
result in a short circuit and is
n o t c o v e r e d b y p r o d u c t
warranty.
Dimensions
Unit: mm
3
0
3
0
3
2
6
25
1
26
7
Push-off button
Armature vertical
adjustment screws
Lock Bolt
Keep Hole
Keep Hole
Magnet Assembly
Armature Assembly
GS705N-30
Lock Bolt
+
-
Power
supply
Magnet bond sensor output
SPDT rated:
0.5A/125VAC, 1A/24VDC
+
-
N.O.
COM.
N.C.
P
o
w
e
r
In
p
u
t
M
a
g
n
e
t
b
o
n
d
s
e
n
s
o
r
o
u
tp
u
t
Vo l t a g e S e l e c t i o n j u m p e r s
Check jumper settings before
connecting the lock to 24 VDC
input power. Damage to the
lock may result from incorrect
jumper settings.
12Vdc
24Vdc
Holding Force
Power Input
Door Gap
Operating Temper.
Current Draw
Monitoring Output
Finish
Up to 1200 lbs (545 Kg) in shear.
12/24 VDC selectable via jumpers +10%
over voltage is acceptable , under voltage
will reduce holding force.
420mA/12 VDC; 210mA/24 VDC The unit
does not require initial voltage increase to
operate.
M a g n e t a n d A r m a t u r e : Z i n c p l a t e d
Housing: Black powder coated
SPDT rating
0.5A/125VAC, 1A/24VDC
2mm
-30°C to +50°C
Magnet bond sensor output,
Make sure that the door and frame is wide and deep enough to install the shear lock and run the wires. Make sure the central lines
on the door frame and door leaf align. Install the magnet assembly in the door frame before installing the armature assembly in the
door leaf.
Before installation, make sure the door, especially double-action doors, always return to the dead center after it is opened. Use
door hinges if necessary.
Control Device
N.C. contact or Access Relay
Install the magnet assembly into the door
frame before installation the armature assembly
into the door leaf. The magnet assembly requires
space to run wires, as wall as space for the
recesses portion of the unit. Make sure that the
position selected for the magnet assembly leaves
enough room on the door to install the armature
assembly.
3.5
5. 9
