Copyright © Gianni industries, inc. All Rights Reserved.
P-MU-DG-200 Ver. A Publish: 2009.11.30 Page: - 4 -/ 5
5. Adding PINs to Relay 1
a:
1. Enter programming mode to select slot position
＊
001~
＊
200 (rapid green LED
flash to indicate the slot position is available)
2. Enter new PIN (1 beep, green LED stay on)
3. Press # (1 beep) back to programming mode
4. Press # again (1 beep) back to standby mode (slow yellow LED flash)
b:
1. Enter programming mode to select slot position
＊
001~
＊
200 (green LED stay
on to indicate the slot position is unavailable)
2. Press 00000 (1 beep) delete the data from the slot position (rapid green LED
flash)
3. Repeat the steps of
5-a
to add new PINs.
6. Adding PINs to Relay 2
a:
1. Enter programming mode to select slot position
＊
201~
＊
210 (rapid red LED
flash to indicate the slot position is available)
2. Enter new PIN (1 beep, red LED stay on)
3. Press # (1 beep) back to programming mode
4. Press # again (1 beep) back to standby mode (slow yellow LED flash)
b:
1. Enter programming mode to select slot position
＊
201~
＊
210 (red LED stay on
to indicate the slot position is unavailable)
2. Press 00000 (1 beep) delete the data from the slot position (rapid red LED flash)
3. Repeat the steps of
6-a
to add new PINs.
7. Change Master Code
1. Enter programming mode.
2. Press
＊
000 + XXXXX (5-digit master code), 1 beep, yellow LED stay on.
3. Press # (1 beep) back to programming mode.
4. Press # again (1 beep) back to standby mode, slow yellow LED flash.
8. Change PIN length
1. Enter programming mode
2. Press
＊
555 + 5~8-digit code, then press # to exit programming mode.
