Operator’s Manual
Turbo 1 -2 - 4
Page .
©GF Gianni Ferrari 10-2001
10
Selection from C) to A) or B) causes the wheels to accelerate suddenly; it is therefore an operation to be performed at
low speed.
SPEED SELECTOR TURBO 2
The selector provides 2 speeds:
SLOW (turtle – lifted lever position) – Speed from 0 to 9 KM/H –
this position should be used only when cutting grass and when
moving at low speed is requested.
FAST (hare – lowered lever position) – Speed from 0 to 18
KM/H – this position should be used when moving.
It is possible to shift from SLOW to FAST speed and viceversa
even during advancement. This operation shall anyway be carried
out at low speed since it could cause the machine to accelerate or
stop suddenly.
9 – STARTING AND USING THE MACHINE
Seat adjustment
The comfort seat can be adjusted in the following positions:
a)
Adjustment according to the operators weight - knob 2.
Weight indicator 3. When using the machine on slopes adjust
the weight 10-20 kg. less than the operator’s weight. This
prevents the engine from stopping due to the seat safety
switch actuation.
b)
Turbo 2-4 only: Vertical adjustment (3 settings). Carry out
this operation when the operator is not seated, lifting the seat
a little then stop; to lower the seat, first lift it as high as it will
go and then release.
c)
Horizontal adjustment - knob 1
d)
Seat back inclination adjustment - knob 4
Adjust the seat to the operator’s requirements as described above.
Steering column adjustment
After having adjusted the seat, adjust the steering
column by slackening the knob as shown in the
picture. Once the correct position has been found,
tighten the knob .
