26
25
3.2 IDE Configuration
·
Hard Disk Write Protect
This item uses for enable or disable write-protection function. This function only
works while access devices through BIOS.
·
IDE Detect time out (Sec)
This item uses for choose ATA/ATAPI devices auto-detection time.
Could be set as:[0][5][10][15][20][25][30][35].
3.3 IO chipset configure
·
OnBoard Floppy Controller
Default:[Enable]
·
Floppy Drive Swap
Swap two floppy drivers' volume label.
·
Serial Port2 Address
Set build-in serial port1's (COM 1) address. Options are:[Disable],[3F8/IRQ4],
[2F8/IRQ3],[3E8/IRQ4],[2E8/IRQ3],[Auto].
Default:[3F8/IRQ4]
·
Serial Port2 Mode
[Normal] mode for mouse and modem application.
If IrDA function is used, then [IrDA ASKIR] mode is recommended.
3.4 PC health configuration
·
H/W Health Function
This setting can open system hardware status display, CPU fan and CPU
temperature can be observed in the COMS. Some new models have added
the CPU overheat alarm and auto power-off function in COMS to protect
hardware, usually set to 80 degrees.
·
CPU Fan Speed Control
CPU FAN modes:[Manual Mode],[Full On Mode],[Thermal Cruise Mode]
Fig 3.5
www.giadatech.com
Fig 3.4
Fig 3.6
