User Manual
© 2017 Cine Gears INC. All Rights Reserved.
10
Transmitter
Fix the four antennas respectively.
Connect the SDI or HDMI video source to the “SDI IN”/”HDMI IN” of transmitter (when both SDI and
HDMI video are inputted, it will auto select the SDI video for transmission).
If needed, you can connect the SDI out (loop through) to other equipment as well.
Connect the DC power to the transmitter or use a battery on the battery plate.
Power on the transmitter.
Set the Channel (must set both transmitter and receiver to the same channel)
Receiver
Fix the six antennas respectively.
Connect the “SDI OUT”/”HDMI OUT” port of the receiver to the monitor or other device.
Connect DC power via power cable or use V-lock battery on the battery plate.
Power on the receiver.
Set the Channel (must set both transmitter and receiver to the same channel).
The “Link” indicator light will glow green and the screen will read “Scanning...” After 10-20s, the video
transmission will be shown on the monitor, and the “Video” indicator light will glow orange on both the
transmitter and the receiver.
4-5 lights
Signal is very strong.
Signal is average. Try changing the channels and checking the cable
connections on the units.
Signal is very weak. Try changing the channels and checking the cable
connections on the units.
2-3 lights
0-1 lights
Signal Indicator Light
The signal indicator light on the receiver will indicate how strong the transmission signal is
between the transmitter and the receiver. Use the table below to determine the signal strength:
